Adjusting The Tone (Loudness); Setting Speakers To Use (Pma-720Ae Only); Using Headphones; Starting Recording - Denon PMA-720AE Owner's Manual

Adjusting the tone (LOUDNESS)

When the sound volume is low and you press LOUDNESS to the
"hON" state, bass and treble sounds, which are hard to hear at a
low volume level, are enhanced so that you can enjoy a more natural
sound.
LOUDNESS
Press on the main unit.
• Press the button again to the "jOFF" state to return to the
original balance.
Setting speakers to use
(PMA-720AE only)
SPEAKERS A B
Press or on the main unit.
• When A (or B) is set to "hON", sound is produced from the
speakers connected to the A (or B) speaker output terminals.
• When both A and B are set to "hON", sound is produced from the
speakers connected to both the A and B speaker output terminals.
• When both A and B are set to "jOFF", no sound is produced
from the speakers. Use this when listening over headphones.

Using headphones

Plug headphones into PHONES jack.
The speaker output turns off when the headphones are plugged in
(PMA-520AE only).
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.

Starting recording

1
Press the input source select
button ( CD, NETWORK, PHONO,
AUX TUNER
or ) to be recorded.
2
Set the recorder to the record mode.
3
Start playing the source to be recorded.
11

Setting the Auto Standby mode

When there is no operation or input signal for 30 minutes, this unit
automatically enters the standby mode.
• The default setting is "On".
Press and hold AMP POWER X for at
least 5 seconds.
• Auto Standby mode is switched between
Off and On.
• The Power indicator indicates Auto Standby
mode Off/On during Standby, as shown
below.
Auto Standby mode "Off" Auto Standby mode "On"
"Lit in red"
• The Power indicator flashes in red during Auto Standby mode
setting.
If you set the Auto Standby mode while the unit is ON, the unit will
enter the standby mode as soon as the Auto Standby mode setting
is completed.
"Unlit"