Dsp Surround Simulation - Denon AVC-A11XV Operating Instructions Manual

Basic Operation
SURROUND
7CH STEREO ENTER PARAMETER
DSP SIMULATION CURSOR

DSP surround simulation

1
Select the surround mode for each input
channel.
Example: DSP surround simulation mode
(Remote control unit) (Remote control unit)
Example: 7CH STEREO mode
(Remote control unit) (Remote control unit)
The surround mode switches in the following
order each time the DSP SIMULATION button is
pressed:
WIDE SCREEN SUPER STADIUM ROCK ARENA
MATRIX JAZZ CLUB
VIDEO GAME MONO MOVIE CLASSIC CONCERT
2
SURROUND PARAMETER
Press the
button.
• Display the surround parameter menu.
The screen for the selected surround mode
appears.
SURROUND
9CH (7CH STEREO)
DSP SIMULATION
ENTER
CURSOR
SURROUND
PARAMETER
3
CURSOR D D H H
Press the or button to
select the various surround parameters.
4
CURSOR F F G G
Press the or button to
adjust the parameters setting.
5
ENTER SURROUND
Press the or
PARAMETER
button to complete the
setting.
• The "7CH STEREO" display changes as shown
below according to the surround back speaker
setting.
SURROUND
DISPLAY
BACK SPEAKER
ON 7CH STEREO
OFF 5CH STEREO
• When "Default" is selected and the CURSOR F F
button is pressed, "CINEMA EQ." and "D.COMP."
are automatically turned off, "ROOM SIZE" is set to
"medium", "EFFECT LEVEL" to "10", "DELAY
TIME" to "30 ms" and "LFE" to "0 dB".
• The "ROOM SIZE" expresses the expansion effect
for the different surround modes in terms of the size
of the sound field, not the actual size of the listening
room.
2 Surround parameters y
EFFECT:
This parameter turns the effect signals with multi
surround mode speaker effects on and off in the
WIDE SCREEN mode. When this parameter is
turned off, the SBL and SBR channel signals are
equivalent to the SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect
signals in the WIDE SCREEN mode. It can be set in
15 steps, from "1" to "15". Set this to a low level if
the positioning or phase of the surround signals
sounds unnatural.
SB CH OUT:
• ON:
Playback is conducted using the surround back
speaker.
• OFF:
Playback is conducted without using the surround
back speaker.
NOTE:
This operation can be performed directly pressing
the SURROUND BACK button on the main unit's panel.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-
small), "medium", "med.l" (medium-large) and
"large". "small" recreates a small sound field,
"large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower
the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set
within the range of 0 to 300 ms.
SW ATT:
This is the parameter for reducing the level of the
subwoofer channel when playing in the EXT. IN input
mode. Depending on the player you are using, the
subwoofer channel's playback level may seem too
high. If so, set "SW ATT" to "ON".
For DENON players, use with the default settings
("OFF").
Subwoofer ON/OFF:
The subwoofer output can be controlled directly.
30
ENGLISH
ENGLISH
Basic Operation