Room Eq Function - Denon AVC-A11XV Operating Instructions Manual

Basic Operation
PCM:
(exclusive PCM signal playback mode)
Decoding and playback are only performed when
PCM signals are being input.
Note that noise may be generated when using this
mode to play signals other than PCM signals.
DTS:
(exclusive DTS signal playback mode)
Decoding and playback are only performed when
DTS signals are being input.
2 Selecting the analog mode
ANALOG
Press the button to switch to the
analog input.
ANALOG:
(exclusive analog audio signal playback mode)
The signals input to the analog input terminals are
decoded and played.
NOTE:
• Input mode when playing DTS sources:
Noise will be output if DTS-compatible CDs or
LDs are played in the "ANALOG" or "PCM"
mode.
When playing DTS-compatible sources, be sure
to connect the source component to the digital
input terminals (OPTICAL/COAXIAL) and set the
input mode to "DTS".
2 Input mode display
Depending on the input signal.
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
• In the EXT.IN mode
2 Input signal display
• DOLBY DIGITAL
Depending on the input signal.
• The "DSD" indicator lights when
the DENON LINK or IEEE1394
• DTS
have been connected and the DSD
signals have been inputted (
page 16, 17).
Depending on the input signal.
• PCM
• The "HDCD" indicator lights when
digital signals are being input with a
player that supports HDCD
playback.
The "DIG." indicator lights when digital signals are
being input properly. If the "DIG." indicator does
not light, check whether the digital input
component setup ( page 42) and connections
are correct and whether the component's power is
turned on.
AL24 processing is activated when PCM signals
are played while the surround mode is set to PURE
DIRECT, DIRECT, STEREO, MULTI CH PURE
DIRECT, MULTI CH DIRECT or MULTI CH IN.
NOTE:
• The "DIG." indicator will light when playing CD-
ROMs containing data other than audio signals,
but no sound will be heard.
ROOM EQ

Room EQ function

The AVC-A11XV's Auto Setup / Room EQ function
offers three correction curves: "Audyssey", "Front",
"Flat". The timbre of the speakers can also be
adjusted manually using a graphic equalizer.
Details of the different correction curves are described
below.
Audyssey:
This adjusts the frequency response of all speakers
to correct the effects of room acoustics.
Front:
This adjusts the characteristics of each speaker to
the characteristics of the front speakers.
Flat:
This the frequency response of all speakers flat.
This is suitable for multi-channel music reproduction,
from discrete music sources such as Dolby Digital
5.1, DTS, DVD-Audio and Super Audio CD.
Manual:
Selects the setting value that was set in the Manual
EQ Setup.
For details of the "Setting the Manual EQ Setup"
( page 48).
22
ENGLISH
ENGLISH
Basic Operation
ROOM EQ
ROOM EQ
Press the button.
• The "Audyssey" is selected, the MultEQ XT
indicator lights green.
• The "Front" or "Flat" is selected, the MultEQ XT
indicator lights red.
The Room EQ switches as follows each time the
ROOM EQ button is pressed.
OFF Audyssey Front Flat Manual
The MultEQ XT indicator also lights red if the
"Speaker Configuration", "Delay Time",
"Channel Level" or "Crossover Frequency" is
set manually after conducting the Auto Setup
procedure.
• The "Audyssey", "Front" and "Flat" Room EQ
curves can be selected after performing the Auto
Setup procedure.