Remote Control Unit Operations During Multi-Source Playback; Other Function; Playing Super Audio Cds With An Ieee1394 Cable - Denon AVC-A11XV Operating Instructions Manual

ENGLISH
Advanced Operation
SOURCE OFF SOURCE ON
MODE SELECTOR
FUNCTION
VOLUME
MUTING
Remote control unit operations
during multi-source playback
1
Select the zone which you want to
MODE SELECTOR
operate pressing the
buttons.
Example: ZONE2
(Remote control unit)
2
SOURCE ON
Press the button to turn on
the zone power.
Press the SOURCE OFF button to turn off the zone
power.
3
Select the input source you wish to
output.
4
The volume of the outputs of the
different zones can be adjusted with the
VOLUME
button on the remote control
unit.
The output level can be controlled only if the
zone volume level is set "Variable" at "Volume
Control" in the "System Setup Menu" (
page 50).
DEFAULT VOLUME SETTING
ZONE2 : –40 dB
ZONE3 : –40 dB
The zone volume can be adjusted within the
range of –80 to 18 dB, in steps of 1 dB.
• Press the MUTING button to mute the audio
temporarily.
The muting level is same as set with "Volume
Control".
• Cancelling muting mode:
Press the MUTING button again, or press the VOLUME
button on the remote control unit.

Other function

FUNCTION SURROUND MODE
Playing Super Audio CDs with an
IEEE1394 cable
1
Select the input source to which
IEEE1394 was assigned
"IEEE1394 Assign" ( page 43, 44) in
the system setup.
Example: CD
(Main unit) (Remote control unit)
• The IEEE1394 indicator lights.
light
2
Select the surround mode.
Example: DIRECT
(Main unit) (Remote control unit)
3
Start playback on the
component.
• The DSD indicator lights.
light
For operating instructions, refer
component's manual.
"DSD DIRECT" is shown on the display when
playing DSD 2-channel signals in the DIRECT
mode. "DSD MULTI DIRECT" is displayed when
playing DSD multi-channel signals in the DIRECT
mode (SB CH OUT "OFF").
39
ENGLISH
Advanced Operation
SOURCE
FUNCTION
ON SCREEN
When playing DSD signals in the DIRECT or PURE
DIRECT mode, the DSD signals are converted into
analog signals. When playing in other surround
modes, the DSD signals are first converted into
PCM signals with a sampling frequency of 88.2
at the
kHz. However, when playing DSD 2-channel
signals in the STEREO mode, they are converted
into PCM signals with a sampling frequency of
176.4 kHz. The input signal and playing status can
be checked by pressing the ON SCREEN button on
the remote control unit.
Example:
When DSD multi-channel signals are played in
the DIRECT mode
Example:
When DSD multi-channel signals are played in
the ROCK ARENA mode
selected
to the
SURROUND
SURROUND
MODE