Port Setup - ZyXEL Communications MES3500-24F User Manual

Table 12 Basic Setting > IP Setup (continued)
LABEL
Delete
Cancel

8.7 Port Setup

Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
Figure 32 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 13 Basic Setting > Port Setup
LABEL
Port
*
Active
Name
Type
MES3500-24/24F User's Guide
DESCRIPTION
Check the management IP addresses that you want to remove in the Delete column,
then click the Delete button.
Click Cancel to clear the selected check boxes in the Delete column.
DESCRIPTION
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable a port. The factory default for all ports is enabled. A port must
be enabled for data transmission to occur.
Enter a descriptive name that identifies this port. You can enter up to 64 alpha-numerical
characters.
Note: Due to space limitation, the port name may be truncated in some web configurator
screens.
This field displays 10/100M for Fast Ethernet connections and 10/100/1000M for Gigabit
connections.
Chapter 8 Basic Setting
95