Firmware Upgrade - ZyXEL Communications MES3500-24F User Manual

In the Maintenance screen, click the Config 1 button next to Reboot System to reboot and load
1
configuration one. The following screen displays.
Figure 168 Reboot System: Confirmation
Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not
2
affect the Switch's configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.

37.5 Firmware Upgrade

Make sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Firmware is uploaded to the current image. See
about images and uploading firmware to a different image.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
Click Management > Maintenance > Firmware Upgrade to view the screen as shown next.
Figure 169 Management > Maintenance > Firmware Upgrade
Type the path and file name of the firmware file you wish to upload to the Switch in the File Path
text box or click Browse to locate it. Select the Rebooting check box if you want to reboot the
Switch and apply the new firmware immediately. (Firmware upgrades are only applied after a
reboot). Click Upgrade to load the new firmware.
After the firmware upgrade process is complete, see the System Info screen to verify your current
firmware version number.
MES3500-24/24F User's Guide
Section 37.8 on page 287
Chapter 37 Maintenance
for more information
285