Igmp Snooping Vlan - ZyXEL Communications MES3500-24F User Manual

24.4 IGMP Snooping VLAN

Click Advanced Applications > Multicast in the navigation panel. Click the Multicast Setting
link and then the IGMP Snooping VLAN link to display the screen as shown. See
on page 187
Figure 95 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN
The following table describes the labels in this screen.
Table 62 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN
LABEL
Mode
Apply
Cancel
VLAN
Name
VID
MES3500-24/24F User's Guide
for more information on IGMP Snooping VLAN.
DESCRIPTION
Select auto to have the Switch learn multicast group membership information of any
VLANs automatically.
Select fixed to have the Switch only learn multicast group membership information of the
VLAN(s) that you specify below.
In either auto or fixed mode, the Switch can learn up to 16 VLANs (including up to five
VLANs you configured in the MVR screen). For example, if you have configured one
multicast VLAN in the MVR screen, you can only specify up to 15 VLANs in this screen.
The Switch drops any IGMP control messages which do not belong to these 16 VLANs.
Note: You must also enable IGMP snooping in the Multicast Setting screen first.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section of the screen to add VLANs upon which the Switch is to perform IGMP
snooping.
Enter the descriptive name of the VLAN for identification purposes.
Enter the ID of a static VLAN; the valid range is between 1 and 4094.
Note: You cannot configure the same VLAN ID as in the MVR screen.
Chapter 24 Multicast
Section 24.1.4
191