Port-Based Q-In-Q - ZyXEL Communications MES3500-24F User Manual

Table 57 Advanced Application > VLAN Stacking (continued)
LABEL DESCRIPTION
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.

23.4.1 Port-based Q-in-Q

Port-based Q-in-Q lets the Switch treat all frames received on the same port as the same VLAN
flows and add the same outer VLAN tag to them, even they have different customer VLAN IDs.
Click Port-based QinQ in the Advanced Application > VLAN Stacking screen to display the
screen as shown.
Figure 91 Advanced Application > VLAN Stacking > Port-based QinQ
The following table describes the labels in this screen.
Table 58 Advanced Application > VLAN Stacking > Port-based QinQ
LABEL DESCRIPTION
Port The port number identifies the port you are configuring.
SPVID SPVID is the service provider's VLAN ID (the outer VLAN tag). Enter the service provider ID (from
1 to 4094) for frames received on this port. See
information on VLAN ID.
Priority Select a priority level (from 0 to 7). This is the service provider's priority level that adds to the
frames received on this port.
"0" is the lowest priority level and "7" is the highest.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
MES3500-24/24F User's Guide
Chapter 23 VLAN Stacking
Chapter 9 on page 97 for more background
183