ZyXEL Communications MES3500-24F User Manual page 43

Table 4 Navigation Panel Links (continued)
LINK
AAA
IP Source Guard
Loop Guard
VLAN Mapping
Layer 2 Protocol
Tunneling
sFlow
PPPoE
Errdisable
Private VLAN
IP Application
Static Routing
DiffServ
DHCP
Management
Maintenance
Access Control
Diagnostic
Syslog
Cluster
Management
MAC Table
ARP Table
Configure Clone
MES3500-24/24F User's Guide
DESCRIPTION
This link takes you to a screen where you can configure authentication,
authorization and accounting services via external servers. The external servers
can be either RADIUS (Remote Authentication Dial-In User Service) or TACACS+
(Terminal Access Controller Access-Control System Plus).
This link takes you to screens where you can configure filtering of unauthorized
DHCP and ARP packets in your network.
This link takes you to a screen where you can configure protection against
network loops that occur on the edge of your network.
This link takes you to screens where you can configure VLAN mapping settings on
the Switch.
This link takes you to a screen where you can configure L2PT (Layer 2 Protocol
Tunneling) settings on the Switch.
This link takes you to screens where you can configure sFlow settings on the
Switch.
This link takes you to screens where you can configure how the Switch gives a
PPPoE termination server additional subscriber information that the server can
use to identify and authenticate a PPPoE client.
This link takes you to a screen where you can configure CPU protection and error
disable recovery.
This link takes you to a screen where you can block traffic between ports in a
VLAN on the Switch.
This link takes you to a screen where you can configure static routes. A static
route defines how the Switch should forward traffic by configuring the TCP/IP
parameters manually.
This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
This link takes you to screens where you can configure the DHCP settings.
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
This link takes you to screens where you can view system logs and can test
port(s).
This link takes you to screens where you can setup system logs and a system log
server.
This link takes you to a screen where you can configure clustering management
and view its status.
This link takes you to a screen where you can view the MAC address and VLAN ID
of a device attached to a port. You can also view what kind of MAC address it is.
This link takes you to a screen where you can view the MAC address – IP address
resolution table.
This link takes you to a screen where you can copy attributes of one port to
(an)other port(s).
Chapter 4 The Web Configurator
43