Configuring Snmp Trap Group - ZyXEL Communications MES3500-24F User Manual

Table 125 Management > Access Control > SNMP (continued)
LABEL
IP
Port
Username
Apply
Cancel

38.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen as shown. Use
the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP
manager.
Figure 175 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 126 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination
IP
Type
Options
MES3500-24/24F User's Guide
DESCRIPTION
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User screen).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Section 38.3.3 on page 292
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
for individual trap descriptions.
Chapter 38 Access Control
297