ZyXEL Communications MES3500-24F User Manual page 82

Chapter 7 System Status and Port Statistics
The following table describes the labels in this screen.
Table 7 Status
LABEL
Port
Name
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter
82
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port Details
screen (refer to Figure 27 on page
This is the name you assigned to this port in the Basic Setting > Port Setup
screen.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or
1000M for 1000Mbps) and the duplex (F for full duplex or H for half). It also
shows the cable type (Copper or Fiber) for the combo ports.
This field displays Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 13.1 on page 122
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port
has been up.
Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
83).
for more information).
MES3500-24/24F User's Guide