Configuring Protocol Based Vlan - ZyXEL Communications MES3500-24F User Manual

Chapter 9 VLAN

9.9 Configuring Protocol Based VLAN

Click Protocol Based VLAN in the VLAN Port Setting screen to display the configuration screen
as shown.
Figure 42 Advanced Application > VLAN > VLAN Port Setting > Protocol Based VLAN
The following table describes the labels in this screen.
Table 20 Advanced Application > VLAN > VLAN Port Setting > Protocol Based VLAN Setup
LABEL
Active
Port
Name
Ethernet-type
VID
Priority
Add
Cancel
108
DESCRIPTION
Check this box to activate this protocol based VLAN.
Type a port number to be included in this protocol based VLAN.
This port must belong to a static VLAN in order to participate in a protocol based
VLAN. See Chapter 9 on page 97
Enter up to 32 alphanumeric characters to identify this protocol based VLAN.
Use the drop down list box to select a predefined protocol to be included in this
protocol based VLAN or select Others and type the protocol number in hexadecimal
notation. For example, the IP protocol in hexadecimal notation is 0800, and Novell
IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not allowed
to be used for protocol based VLANs.
Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN
which you defined in the Advanced Applications > VLAN screens.
Select the priority level that the Switch will assign to frames belonging to this VLAN.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
for more details on setting up VLANs.
MES3500-24/24F User's Guide