Link Aggregation Control Protocol - ZyXEL Communications MES3500-24F User Manual

17.5 Link Aggregation Control Protocol

Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See
aggregation.
Figure 71 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 42 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
Link Aggregation
Control Protocol
Active
System Priority
Group ID
MES3500-24/24F User's Guide
Section 17.2 on page 148
DESCRIPTION
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the LACP
"server". The LACP "server" controls the operation of LACP setup. Enter a number to set
the priority of an active port using Link Aggregation Control Protocol (LACP). The smaller
the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
Chapter 17 Link Aggregation
for more information on dynamic link
153