Chapter 38 Access Control
38.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen to
configure your SNMP settings.
Figure 174 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 125 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
Set Community
Trap Community
Trap Destination
Version
296
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Enter the Set Community, which is the password for incoming Set- requests from the
management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Use this section to configure where to send SNMP traps from the Switch.
Specify the version of the SNMP trap messages.
MES3500-24/24F User's Guide