Configure A Static Vlan - ZyXEL Communications MES3500-24F User Manual

Chapter 9 VLAN

9.5.3 Configure a Static VLAN

Use this screen to configure and view 802.1Q VLAN parameters for the Switch. See
page 97 for more information on static VLAN. To configure a static VLAN, click Static VLAN in the
VLAN Status screen to display the screen as shown next.
Figure 37 Advanced Application > VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 17 Advanced Application > VLAN > Static VLAN
LABEL
ACTIVE
Name
VLAN Group ID
Port
*
Control
102
DESCRIPTION
Select this check box to activate the VLAN settings.
Enter a descriptive name for the VLAN group for identification purposes. This name consists
of up to 64 printable characters; spaces are allowed.
Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
The port number identifies the port you are configuring.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select Normal for the port to dynamically join this VLAN group using GVRP. This is the
default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Section 9.1 on
MES3500-24/24F User's Guide