ZyXEL Communications MES3500-24F User Manual page 328

Chapter 44 Configure Clone
The following table describes the labels in this screen.
Table 141 Management > Configure Clone
LABEL
Source/
Destination
Port
Basic Setting
Advanced
Application
Apply
Cancel
328
DESCRIPTION
Enter the source port under the Source label. This port's attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (you configured in the Basic Setting menus) should be copied to
the destination port(s).
Select which port settings (you configured in the Advanced Application menus) should be
copied to the destination ports.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500-24/24F User's Guide