Use these commands to configure protocol based VLANs on the Switch.
70.1 Protocol-based VLAN Overview
Protocol-based VLANs allow you to group traffic based on the Ethernet protocol you specify. This allows
you to assign priority to traffic of the same protocol.
See also
Chapter 86 on page 318
VLAN commands.
70.2 Command Summary
The following section lists the commands for this feature.
Table 169 protocol-based-vlan Command Summary
COMMAND
show interfaces config <port-
list> protocol-based-vlan
interface port-channel <port-
list>
Protocol-based VLAN
for subnet-based VLAN commands and
Ethernet Switch CLI Reference Guide
C
H A P T E R
Commands
DESCRIPTION
Displays the protocol based VLAN settings for the specified
port(s).
Enters subcommand mode for configuring the specified
ports.
267
70
Chapter 96 on page 339
M
E
C
for
P
3
13