Figure 56
Figure 56 Groups > Cisco WLC Config > Security Navigation Illustration
Configuring Management Settings for Cisco WLC
AMP allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. Users should be
able to configure up to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global
Groups. To define SNMP and server settings, go to the Groups > Cisco WLC Config > Management page,
illustrated in
Figure 57 Groups > Cisco WLC Config > Management Navigation Illustration
Configuring Group PTMP Settings
The Groups > PTMP configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base
stations in the device group. Subscriber stations must be in the same group as all base stations with which they
might connect.
Perform the following steps to configure these functions.
1. Go to the Groups > List page and select the group for which to define PTMP settings by selecting the group
name. Alternatively, select Add from the Groups > List page to create a new group, define a group name. In
either case, the Monitor page appears.
2. Select the PTMP tab in the AMP navigation menu.
Figure 58 Groups > PTMP Page Illustration
94 | Configuring and Using Device Groups in AMP
illustrates these components and this navigation:
Figure
57.
Figure 58
illustrates this page.
Dell PowerConnect W-AirWave | Version 7.3