Dell PowerConnect W-Airwave User Manual page 174

Table 100 RAPIDS > List Column Definitions (Continued)
Column
RSSI
Network Type
Encryption Type
Ch
LAN MAC Address
LAN Vendor
Radio MAC Address
Radio Vendor
OS
Model
IP Address
Last Discovering AP
Switch/Router
Port
Notes
Last Seen
174 | Using RAPIDS and Rogue Classification
Description
Displays Received Signal Strength Indication (RSSI) designation, a measure of the power present in a
received radio signal.
Displays the type of network in which the rogue is present, for example:
Ad-hoc—This type of network usually indicates that the rogue is a laptop that attempts to create a

network with neighboring laptops, and is less likely to be a threat.
AP—This type of network usually indicates an infrastructure network, for example. This may be

more of a threat.
Unknown—The network type is not known.

Displays the encryption that is used by the device. Possible contents of this field include the following
encryption types:
Open—No encryption

WEP—Wired Equivalent Privacy

WPA—Wi-Fi Protected Access

Generally, this field alone does not provide enough information to determine if a device is a rogue, but it
is a useful attribute. If a rogue is not running any encryption method, you have a wider security hole
than with an AP that is using encryption.
Indicates the most recent RF channel on which the rogue was detected.
NOTE: It may be detected on more than one channel if it contains more than one radio.
The LAN MAC address of the rogue device.
Indicates the LAN vendor of the rogue device, when known.
Displays the MAC address for the radio device, when known.
Indicates the radio vendor of the rogue device, when known.
This field displays the OS of the device, as known. OS is the result of a running an OS port scan on a
device. An IP addresses is required to run an OS scan. The OS reported here is based on the results of
the scan.
Displays the model of rogue device, if known. This is determined with a fingerprint scan, and this
information may not always be available.
Displays the IP address of the rogue device. The IP address data comes from fingerprint scans or ARP
polling of routers and switches.
Displays the most recent AP to discover the rogue device. The device name in this column is taken from
the device name in AMP. Click the linked device name to be redirected to the APs/Devices > Monitor
page for that AP.
Displays the switch or router where the device's LAN MAC address was last seen.
Indicates the physical port of the switch or router where the rogue was last seen.
Indicates any notes about the rogue device that may have been added.
Indicates the date and time the rogue device was last seen.
Dell PowerConnect W-AirWave | Version 7.3