Enabling Cisco Discovery Protocol (Cdp); Authorizing Devices To Amp From Aps/Devices > New Page - Dell PowerConnect W-Airwave User Manual

7. Go to the APs/Devices > New page to see a full list of the newly discovered devices that the scan detected.
Figure 71
NOTE: This page is only visible to users with the AMP Administrator role, or roles that have "Allow authorization of APs/Devices"
enabled in AMP Setup > Roles.
Figure 71 APs/Devices > New Page Illustration
What Next?
To authorize one or more devices to a group, see

Page" on
To delete a device altogether from AMP, select the corresponding check box for each device, and select

Delete.
Dell PowerConnect W-Series thin APs can have Dell PowerConnect W AP Group specified and Cisco thin

APs can have LWAPP AP Group specified when they are authorized.

Enabling Cisco Discovery Protocol (CDP)

CDP uses the polling interval configured for each individual Cisco switch or router on the Groups > List page.
AMP requires read-only access to a router or switch for all subnets that contain wired or wireless devices. The
polling interval is specified on the Group > Basic page.
Authorizing Devices to AMP from APs/Devices > New Page
Once you have discovered devices on your network, add these devices to a group and specify whether the device is
to be placed in Manage Read/Write or Monitor Only mode. To configure a new group, refer to
Using Device Groups in AMP" on
In Manage Read/Write mode, AMP compares the device's current configuration settings with the Group
configuration settings and automatically updates the device's configuration to match the Group policy.
In Monitor Only mode, AMP updates the firmware, compares the current configuration with the policy, and
displays any discrepancies on the APs/Devices > Audit page, but does not change the configuration of the device.
CAUTION: Put devices in Monitor Only mode when they are added to a newly established device group. This avoids overwriting
any important existing configuration settings.
Dell PowerConnect W-AirWave | User Guide
illustrates this page.
page 109.
page 69.
"Authorizing Devices to AMP from APs/Devices > New
Discovering, Adding, and Managing Devices | 109
"Configuring and