Dell PowerConnect W-Airwave User Manual page 38

5. Locate the Device Configuration section and adjust the settings.
values of this section.
Table 11 AMP Setup > General > Device Configuration Section Fields and Default Values
Setting
Guest User
Configuration
Allow WMS offload
configuration in
monitor-only mode
Allow disconnecting
users while in monitor-
only mode
Allow non-UTF8
characters
Use Global Dell
PowerConnect W
Configuration
5. Locate the AMP Features section and adjust settings to enable or disable VisualRF and RAPIDS.
describes these settings and default values
Table 12 AMP Setup > General > AMP Features Fields and Default Values
Setting
Display VisualRF
Display RAPIDS
Display Helpdesk
6. Locate the External Logging section and adjust settings to send audit and system events to an external syslog
server.
Message button once any of the logging options are enabled.
Table 13 AMP Setup > General > External Logging Section Fields and Default Values
Setting
Include event log
messages
Syslog Server
Syslog Port
38 | Configuring AMP
Default Description
Disabled Enables or prevents guest users to/from pushing configurations to devices. Options are
Disabled (default), Enabled for Devices in Manage (Read/Write), Enabled for all
Devices.
No When Yes is selected, you can enable the ArubaOS WMS offload feature on the
Groups > Basic page for WLAN switches in Monitor Only mode. Enabling WMS offload
does not cause a controller to reboot. This option is supported only for Aruba Networks
and Dell PowerConnect W-Series devices.
No Sets whether you can deauthenticate a user for a device in monitor-only mode. If set to
No, the Deauthenticate User button for in a Users > User Detail page is enabled only for
Managed devices.
No Whether AMP can use character sets other than UTF-8 for configuration settings.
Yes Enables Dell PowerConnect W configuration profile settings to be globally configured
and then assigned to device groups. If disabled, settings can be defined entirely within
Groups > Aruba Config instead of globally.
NOTE: Changing this setting may require importing configuration on your devices.
When an existing Aruba configuration setup is to be converted from global to group,
follow these steps:
1. Set all the devices to Monitor Only mode before setting the flag.
2. Each device Group will need to have an import performed from the Audit page of a
3. All of the thin APs need to have their settings imported after the device group
4. If the devices were set to Monitor Only mode, set them back to Managed mode.
Default Description
No Enable or disable the VisualRF navigation tab.
No Enable or disable the RAPIDS navigation tab.
No Enable or disable the Helpdesk navigation tab and Helpdesk links
Table 13 describes these settings and default values. You can send a test message using the Send Test
Default Description
No Select Yes to send event log messages to an external syslog server.
N/A Enter the IP address of the syslog server.
514 Enter the port of the syslog server.
controller in the AMP group.
settings have finished importing.
.
Table 11 describes the settings and default
Dell PowerConnect W-AirWave | Version 7.3
Table 12