Moving A Device From Monitor Only To Manage Read/Write Mode; Configuring Ap Settings - Dell PowerConnect W-Airwave User Manual

Compare two configurations to highlight the specific lines that are mismatched. The Audit page provides links to
the AMP pages where any mismatched settings can be configured.
NOTE: These procedures assume you are familiar with the function buttons available to save, apply, revert, and so on. For details
on button functions, see

Moving a Device from Monitor Only to Manage Read/Write Mode

Once the device configuration status is Good on the APs/Devices > List page, or once you have verified all
changes that will be applied to the device on the APs/Devices > Audit page, you can safely shift the device from
Monitor Only mode to Manage Read/Write mode.
NOTE: Once a device is in Manage mode, AMP will push a new configuration to the device in the event that the actual device
configuration does not match the AMP configuration for that device.
To move a device from Monitor Only to Manage Read/Write mode, perform the following steps.
1. Go to the APs/Devices > List page and select the wrench icon next to the name of the AP to be shifted from
Monitor Only mode to Manage Read/Write mode. This directs you to the APs/Devices > Manage page.
2. Locate the General area as shown in
Figure 97 APs/Devices > Manage > General Section Illustration
3. Select Manage Read/Write on the Management Mode field.
4. Select Save and Apply, then Confirm Edit on the confirmation page to retain these settings and to push
configuration to the device.
5. For device configuration changes that require the device to reboot, use the Schedule function to push the
changes at a time when WLAN users will not be affected.
6. To move multiple devices into managed mode at once, use the Modify devices link. For more information,
refer to

Configuring AP Settings

1. Browse to the APs/Devices > List page and select the wrench icon next to the device whose AP settings you
want to edit. This directs you to the Manage page for that device.
132 | Discovering, Adding, and Managing Devices
"Buttons and Icons" on page 25
"Modifying Multiple Devices" on
.
Figure 97.
page 100.
Figure 98 illustrates this page.
Dell PowerConnect W-AirWave | Version 7.3