Dell PowerConnect W-Airwave User Manual page 40

Table 14 AMP Setup > General > Historical Data Retention Fields and Default Values (Continued)
Setting
Interface Status
History
(0-550 days, zero
disables)
Interfering Devices (0-
550 days, zero
disables)
Device Events (Syslog,
Traps)
8. Locate the Firmware Upgrade Defaults section and adjust settings as required. This section allows you to
configure the default firmware upgrade behavior for AMP.
of this section.
Table 15 AMP Setup > General > Firmware Upgrade Defaults Fields and Default Values
Setting
Allow firmware
upgrades in monitor-
only mode
Simultaneous Jobs (1-
20)
Simultaneous Devices
Per Job
(1-1000)
Failures before
stopping (0-20)
9. Locate the Additional AMP Services section, and adjust settings as required.
and default values of this section.
Table 16 AMP Setup > General > Additional AMP Services Fields and Default Values
Setting
Enable FTP Server
Enable RTLS Collector
40 | Configuring AMP
Default Description
425 Sets the number of days AMP retains historical information on interface status. Setting
this value to 0 disables this function.
14 Sets the number of days AMP retains historical information on interfering devices. Setting
this value to 0 disables this function.
2 Sets the number of days AirWave retains historical information on device events such as
syslog entries and SNMP traps. Setting this value to 0 disables this function. Refer to
"Viewing Device Events in System > Syslog & Traps" on
Default Description
No If Yes is selected, AMP upgrades the firmware for APs in Monitor Only mode. When AMP
upgrades the firmware in this mode, the desired configuration are not be pushed to AMP.
Only the firmware is applied. The firmware upgrade may result in configuration changes.
AMP does not correct those changes when the AP is in Monitor Only mode.
20 Defines the number of jobs AMP runs at the same time. A job can include multiple APs.
20 Defines the number of devices that can be in the process of upgrading at the same time.
AMP only runs one TFTP transfer at a time. As soon as the transfer to a device has
completed, the next transfer begins, even if the first device is still in the process of
rebooting or verifying configuration.
1 Sets the default number of upgrade failures before AMP pauses the upgrade process.
User intervention is required to resume the upgrade process. Setting this value to 0
disables this function.
Default Description
No Enables or disables the FTP server on AMP. The FTP server is only used to manage Cisco
Aironet 4800 APs. Disabling the FTP server if you do not have any Cisco Aironet 4800 APs in
the network.
No Enables or disables the RTLS Collector, which is used to allow ArubaOS controllers to send
signed and encrypted RTLS (real time locating system) packets to VisualRF-- in other
words, AMP becomes the acting RTLS server. The RTLS server IP address must be
configured on each controller. This function is used for VisualRF to improve location
accuracy and to locate chirping asset tags. This function is supported only for Dell
PowerConnect W, Alcatel-Lucent and Aruba Networks devices.
With selection of Yes, the following additional fields appear, which you should populate to
match the settings configured on the controller:
RTLS Port—Specify the port for the AMP RTLS server.

RTLS Username—Enter the user name used by the controller to decode RTLS

messages.
RTLS Password—Enter the RTLS server password that matches the controllers' value.

page 181.
Table 15 describes the settings and default values
Table 16
Dell PowerConnect W-AirWave | Version 7.3
describes the settings