Dell PowerConnect W-Airwave User Manual page 111

2. Select Add, and the Device Communications and Location sections appear, illustrated in
Figure 73 Device Setup > Add > Device Communications and Location Sections
3. Complete these Device Communications and Location settings for the new device.
describes the contents of this page. Settings may differ from device to device. In several cases, the default
values from any given device derive from the Device Setup > Communication page.
Table 70 Device Communication and Location Fields and Default Values
Setting
Name
IP Address
SNMP Port
Community
String (Confirm)
SNMPv3
Username
Auth Password
(Confirm)
Privacy
Password
(Confirm)
SNMPv3 Auth
Protocol
Dell PowerConnect W-AirWave | User Guide
Default
None
None
161
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Description
User-configurable name for the AP (maximum of 20 characters).
IP address of the device. This field is required.
Port AMP uses to communicate with the AP using SNMP.
Community string used to communicate with the AP.
NOTE: The Community String should have RW (Read-Write) capability.
New, out-of-the-box Cisco devices typically have SNMP disabled and a
blank username and password combination for HTTP and Telnet. Cisco
supports multiple community strings per AP.
If you are going to manage configuration for the device, this field provides
a read-write user account (SNMP, HTTP, and Telnet) within the Cisco
Security System for access to existing APs. AMP initially uses this
username and password combination to control the Cisco AP. AMP
creates a user-specified account with which to manage the AP if the User
Creation Options are set to Create and user Specified as User.
SNMPv3 privacy password.
Drop-down menu that allows you to enable the SNMPv3 authentication
protocol to the device being added.
Discovering, Adding, and Managing Devices | 111
Figure 73.
Table 70 further