Dell PowerConnect W-Airwave User Manual page 120

Table 73 APs/Devices > Monitor > Wired Interfaces Fields and Descriptions (Continued)
Field
Operational Status
Duplex
Aruba Port Mode
Input Capacity
Output Capacity
Table 74
Table 74 APs/Devices > Monitor Graphical Data
Graph
Users
Bandwidth
CPU Utilization
Memory Utilization
Table 75
Table 75 APs/Devices > Monitor > Connected Users Fields and Default Values
Field
Username
Device Type
Role
MAC Address
Radio
Association Time
Duration
120 | Discovering, Adding, and Managing Devices
Description
Displays the current status of the interface. If an interface is Up, then AMP is able to ping it and fetch
SNMP information. If the AP is listed Down then AMP is either unable to ping the interface or unable to
read the necessary SNMP information from the device.
Full or half
Tunnel
The input capacity of the interface
The output capacity of the interface
describes interactive graph information on this page.
Description
Shows the max and average user count reported by the device radios for a configurable period of time.
User count for controllers are the sum of the user count on the associated APs. Checkboxes below the
graph can be used to limit the data displayed.
Shows the bandwidth in and out reported by the device for a configurable period of time. Bandwidth for
controllers is the sum of the associated APs. Checkboxes below the graph can be used to limit the data
displayed.
Reports overall CPU utilization (not on a per-CPU basis) of the device.
Reports average used and free memory and average max memory for the device.
describes the fields and information displayed for the Connected Users display.
Description
Provides the name of the User associated to the AP. AMP gathers this data in a variety of ways. It can be
taken from RADIUS accounting data or traps.
The type of device the user is using as determined by the Device Type Rules set up by an administrator in
AMP Setup > Device Type Setup. For more information, refer to
The role of the connected user.
Displays the Radio MAC address of the user associated to the AP. Also provides a link that redirects to the
Users > Detail page.
Displays the radio to which the user is associated.
Displays the first time AMP recorded the MAC address as being associated.
Displays the length of time the MAC address has been associated.
"Setting Up Device Types" on
Dell PowerConnect W-AirWave | Version 7.3
page 57.