Setting Triggers For Users; Setting Triggers For Radius Authentication Issues - Dell PowerConnect W-Airwave User Manual

Setting Triggers for Users

Perform the following steps to configure user-related triggers.
a. Choose a trigger type from the Users category, listed in the Type drop-down menu. See
109
type.
Table 109 User Trigger Types and Condition Settings
User Trigger
Option
New User
Connected Users
User Bandwidth This trigger type indicates that the sustained rate of bandwidth used by an individual user has exceeded a
Inactive Tag
b. Repeat this procedure for as many triggers and conditions as desired. Refer to the start of
Triggers" on page 183

Setting Triggers for RADIUS Authentication Issues

Perform the following steps to configure RADIUS-related triggers.
a. Choose a trigger type from the RADIUS... list in the drop-down Type menu.
describes the condition settings for each RADIUS Authentication trigger
Table 110 RADIUS Authentication Trigger Types and Condition Settings
Option
User RADIUS
Authentication Issues
Device RADIUS
Authentication Issues
Total RADIUS
Authentication Issues
b. Repeat this procedure for as many triggers and conditions as desired. Refer to the start of
Triggers" on page 183
188 | Performing Daily Administration in AirWave
itemizes and describes the User-related trigger types, and condition settings for each discovery trigger
Description
This trigger type indicates when a new user has associated to a device within a defined set of groups or
folders. Note that the New User trigger type does not require the configuration of any condition settings, so
the Condition section disappears.
This trigger type indicates when a device (based on an input list of MAC addresses) has associated to the
wireless network. It is required to define one or more MAC addresses with the field that appears.
predefined threshold for more than a specified period, in seconds (such as more than 1500kbps for more
than 120 seconds).
Once you choose this trigger type, select Add New Trigger Condition to specify the bandwidth
characteristics that triggers an alert. You can apply multiple conditions to this type of trigger.
The Value field requires that you input a numerical figure for kilobits per second (kbps).
This tags flags events in which an RFID tag has not been reported back to AMP by a controller for more than
a certain number of hours. This trigger can be used to help identify inventory that might be lost or stolen. Set
the time duration for this trigger type if not already completed.
to create a new trigger.
Description
This trigger type sets the threshold for the maximum number of failures before an alert is issued for a
user. Select Add New Trigger Condition to specify the count characteristics that trigger an alert. The
Option, Condition, and Value fields allow you to define the numeric value of user issues.
This trigger type sets the threshold for the maximum number of failures before an alert is issued for a
device. The Option, Condition, and Value fields allow you to define the numeric value of user issues.
This trigger sets the threshold for the maximum number of failures before an alert is issued for both
users and devices.
to create a new trigger.
Figure
"Creating New
Table 110 itemizes and
type.
"Creating New
Dell PowerConnect W-AirWave | Version 7.3
131. Table