Dell PowerConnect W-Airwave User Manual page 103

Figure 65 Groups > List Page Illustration
To set a group as a Global Group, go to the Groups > Basic configuration page for an existing or a newly

created group. Select Yes for the Is Global Group field under the Global Group section.
When the change is saved and applied, the group will have a checkbox next to fields.

configuration page.
Figure 66 Groups > Basic Page for a Global Group (partial view)
When a Global Group configuration is pushed to Subscriber Groups, all settings are static except for settings

with the checkbox selected; for fields with checkboxes selected, the value or setting can be changed on the
corresponding tab for each managed group. In the case of the Groups > SSIDs configuration page, override
options are available only on the Add configuration page (go to the Groups > SSIDs configuration page and
select Add). Global templates are also configurable as part of Global Groups; for more information, see
"Creating and Using Templates" on
Once Global Groups have been configured, groups may be created or configured to subscribe to a particular

Global Group. Go to the Groups > Basic configuration page of a group and locate the Use Global Groups
section. Select the Yes radio button and select the name of the Global Group from the drop-down menu.
Then select Save and Apply to make the changes permanent.
Figure 67 Groups > Basic > Managed Page Illustration
Once the configuration is pushed, the unchecked fields from the Global Group appears on the Subscriber

Group as static values and settings. Only fields that had the override checkbox selected in the Global Group
appear as fields that can be set at the level of the Subscriber Group. Any changes to a static field must be
made on the Global Group.
Dell PowerConnect W-AirWave | User Guide
page 147.
Figure 67
Figure 66
illustrates this page.
Configuring and Using Device Groups in AMP | 103
illustrates this