Adding Multiple Devices From A Csv File - Dell PowerConnect W-Airwave User Manual

Table 70 Device Communication and Location Fields and Default Values (Continued)
Setting
SNMPv3 Privacy
Protocol
Telnet/SSH
Username &
Password
(Confirm)
"enable"
Password
(Confirm)
HTTP Username
& Password
Auth Password
Privacy
Password
4. In the Location field, select the appropriate group and folder for the device.
5. At the bottom of the page, select either the Monitor Only or Management read/write radio button. The
choice depends on whether or not you wish to overwrite the Group settings for the device being added. For
more information and a detailed procedure, see
on page 109.
NOTE: If you select Manage read/write, AMP overwrites existing device settings with the Group settings. Place newly discovered
devices in Monitor read/only mode to enable auditing of actual settings instead of Group Policy settings.
6. Select Add to finish adding the devices to the network.

Adding Multiple Devices from a CSV File

You can add devices in bulk from a CSV file to AMP. Here you also have the option of specifying vendor name
only, and AMP will automatically determine the correct type while bringing up the device. If your CSV file
includes make and model information, AMP will add the information provided in the CSV file as it did before. It
will not override what you have specified in this file in any way.
The CSV list must contain the following columns:
IP Address

SNMP Community String

Name

Type

Auth Password

SNMPv3 Auth Protocol

112 | Discovering, Adding, and Managing Devices
Default
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Taken from Device Setup >
Communication
Description
Drop-down menu that allows you to enable SNMPv3 privacy protocol to
the device being added.
Telnet username and password for existing Cisco IOS APs. AMP uses the
Telnet username/password combination to manage the AP and to enable
SNMP if desired.
NOTE: New, out-of-the-box Cisco IOS-based APs typically have SNMP
disabled with a default telnet username of Cisco and default password of
Cisco. This value is required for management of any existing Cisco IOS-
based APs.
Password that allows AMP to enter enable mode on the device.
HTTP password used to manage the device initially, and to enable SNMP if
desired.
SNMPv3 authentication password.
NOTE: SNMPv3 supports three security levels: (1) no authentication and
no encryption, (2) authentication and no encryption, and (3) authentication
and encryption. AMP currently only supports authentication and
encryption.
SNMPv3 privacy password.
NOTE: SNMPv3 supports three security levels: (1) no authentication and
no encryption, (2) authentication and no encryption, and (3) authentication
and encryption. AMP currently only supports authentication and
encryption.
"Authorizing Devices to AMP from APs/Devices > New Page"
Dell PowerConnect W-AirWave | Version 7.3