Downloading Software - Barco ScreenPRO-II User Manual

`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Software Upgrade Overview
pçÑíï~êÉ=réÖê~ÇÉ=lîÉêîáÉï
Firmware files for the ScreenPRO-II Controller system are loaded into the hardware at
power-up. These files are stored in the unit's onboard flash memory, which can be
upgraded using a serial or Ethernet connection to a PC (or laptop).
The desired connection is made through the Console or Ethernet port on the ScreenPRO-
II Controller's rear panel, in conjunction with the "Flash Loader" utility supplied with each
upgrade. The Flash Loader enables you to update the Flash memory with the latest
software revision. The utility should be run from a PC's hard drive (recommended).
e~êÇï~êÉ=oÉèìáêÉãÉåíë
The following hardware items are required to upgrade the ScreenPRO-II Controller:
•
If you elect to connect serially, a serial cable conforming to EIA RS-232 specifications (e.g.,
standard modem cable) is required. The cable should have a DB-9 male connector on one
end (for connection to the ScreenPRO-II Controller's Console port), and the appropriate
connector on the other end for connection to your PC (typically, a DB-9).
pçÑíï~êÉ=oÉèìáêÉãÉåíë
The following list outlines software requirements for upgrading the ScreenPRO-II
Controller:
•
•
Software files can be downloaded from either the Folsom FTP site or the Barco Folsom
website, as described in the following "
270
IBM compatible computer with an available COM port or Ethernet port.
Ensure that your PC (or laptop) uses the Windows
systems.
Software files:
~
Flash File Loader. (This software enables the PC to send commands to
the ScreenPRO-II Controller.)
~
ScreenPRO-II Controller software
~
What's New File
Note All software files listed above (and more) are contained in the
file that you will download.
®
2000 or XP operating

Downloading Software

" section on page 271.
ScreenPRO-II Controller • User's Guide