Barco ScreenPRO-II User Manual page 223

6. Operations
`äÉ~êáåÖ=aÉëíáå~íáçåë
Use the following steps to clear destinations:
1.
All
2.
oçìíáåÖ=pçìêÅÉë=íç=aÉëíáå~íáçåë
When routing sources to both standard and Aux destinations, please note:
•
•
•
Use the following steps to route a source to a destination (or multiple destinations):
1.
2.
3.
4.
5.
6.
7.
ScreenPRO-II Controller • User's Guide
To clear all destinations, double-punch the All button.
To clear a single destination (or multiple destinations) from an active group, turn
DEST AUX on or off as desired, then simultaneously press the destinations that
you want to remain on .
Destinations 1 , 2 and 3 are active. To clear destination 2 , simultaneously
press destinations 1 and 3 .
Remember that the Destination/Aux Bus is one bus — it is not two separate and
independent buses.
Any source that you select will apply to all enabled buses — even if that bus is not
currently visible (due to the state of the DEST AUX button).
Any transition that you perform will apply to all enabled buses — even if that bus is
not currently visible (due to the state of the DEST AUX button).
On the Destination/Aux Bus , enable or disable the DEST AUX button as
desired.
Enable only the destination button(s) on which you want to pend a route.
For "standard" destinations, select the desired layer ( LAYER A or LAYER B ).
This step is not required for an Aux bus route.
On the Source Selection Bus , select the source that you want to route to the
selected destination(s).
Note At this point, the route is pending on Preview. You are free to
manipulate the source (e.g., PIP and Key), but the route will
not occur until the destination is enabled, and the next
transition is performed.
Repeat steps 1 through 3 for additional source-to-destination combinations.
Enable all destinations that you want to transition.
Perform the desired transition in the normal manner. Once performed, the
pending route is completed.
Note If you want to clear the pending route prior to performing it,
simply clear the lit Aux destination(s).
Working with Destinations
223