Troubleshooting Ethernet Communication - Barco ScreenPRO-II User Manual

8.
9.
10. In the dialog, select " Complete_Load.sld " and click Open . The ScreenPRO-II
11. It takes several minutes to load the flash memory. When complete, the Flash
12. Cycle power on the ScreenPRO-II Controller, and exit the Flash Loader utility.
13. On ScreenPRO-II Controller, perform a factory reset. In Chapter 5, refer to the
14. On the ScreenPRO-II Controller, verify that the new software has been loaded
qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå
Use the following steps to determine the IP address of ScreenPRO-II Controller, and
establish proper communications:
1.
2.
3.
ScreenPRO-II Controller • User's Guide
Click the Connect button. If the connection is successfully, the message
" Connect via Ethernet successful " appears in the Flash Loader's Status Bar . If
you cannot connect, refer to the "
section on page 275.
To upload files to the ScreenPRO-II Controller, click " Open script file to read and
upload ."
Controller menu should immediately display the " System in LOADER MODE "
message.
Loader utility displays the " Upload Complete " message. Click OK to continue.
" Return to Factory Default
correctly. Press { HOME } > SYSTEM > { SW VER } to display the Software
Version Menu .
Note The default IP address is 192.168.0.2 .
Turn on the ScreenPRO-II Controller. Press { HOME } > SYSTEM > { NETWORK
SETUP } to display the Network Setup Menu .
Make a note of the IP address.
Attempt to ping the ScreenPRO-II Controller as follows:
a. Connect ScreenPRO-II Controller's Ethernet port to a Hub or Switch.
b. Connect the Ethernet Hub or Switch to your PC. A totally "local" network
is recommended, without IP connections to the outside world.
c. Turn on the PC or laptop.
d. Open a command prompt window on the PC. Click Start > Programs >
Accessories > Command Prompt .
e. On the command prompt line, type:
ping 192.168.0.2
... followed by Enter .
Note Use the unit's actual IP address, as determined in step 2
above.
f. If the computer is able to successfully communicate with the
ScreenPRO-II Controller, you will see a series of " replies " from the
target IP address. Repeat the upgrade procedure as outlined in the
" Ethernet Upgrade Method
`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Troubleshooting Ethernet Communication

" section on page 189 for instructions.
" section on page 274.
Ethernet Upgrade Method
"
275