Barco ScreenPRO-II User Manual page 132

4. Menu Orientation
System Menu
lìíéìí=m~íÅÜ=jÉåì
From the Router Specification Menu , press
Patch Menu .
B
A
C
K
Figure 4-34. Output Patch Menu (sample)
The Output Patch Menu allows you to associate router outputs to ScreenPRO-II inputs.
When a router is chosen on the Router Specification Menu , you then use the Output
Patch Menu to associate a specific output with a ScreenPRO-II ID and input. This process
creates a unique " Output Patch Table " for each defined router .
The following functions are provided:
•
•
•
•
•
•
In Chapter 5, refer to the "
about the system's default Output Patch Table .
132
OUTPUT PATCH
Router Output
Device ID
SP Input
Mixer Layer
SP Input is mapped to
MATRIXPRO1 Output 1
Set Device ID to NONE to define
the Router Output as an AUX.
Router Output — selects the specific router output that is being patched. The
selectable range is 1 to the number of outputs defined in the Router
Specification Menu (e.g., 1 - 16 ).
Device ID — selects the ScreenPRO-II ID to which the Router's output will be
connected. The selectable range is 1 - 32 .
Note If " None " is selected, the output is designated as an Aux
output.
SP Input — selects the physical ScreenPRO-II input to which the router's output
is patched.
Mixer Layer — this line displays N/A , as it does not apply to ScreenPRO-II.
Press { ADD PATCH } to confirm any change that you make on the menu. As you
dial through the choices, the " SP Input is mapped to " lines will show if the current
choice is already in use. If the patch already exists and you "add" it, you will be
asked to confirm.
{ }
Press
DELETE PATCH
selected router output. This function is an excellent starting point if you are
uncertain about specific output patch settings.
Router Setup
{
OUTPUT PATCH
MATRIXPRO1
SP 1
[ N/A ]
ADD DELETE
PATCH PATCH
to delete all "Output Patch Table" registers for the
" section on page 193 for important information
ScreenPRO-II Controller • User's Guide
}
to display the Output
1
N
A
V
1
A
D
J