Barco ScreenPRO-II User Manual page 118

4. Menu Orientation
System Menu
•
•
•
•
•
•
•
118
SP to Add — (as you rotate the ADJ knob), lists all available ScreenPRO-II units
that can be assigned to the selected destination.
number. If a ScreenPRO-II is currently assigned to another destination, it will not
appear in the list.
SP to Remove — lists all assigned ScreenPRO-II units that can be removed from
the selected destination.
Routing Mode — enables you to set the ScreenPRO-II's routing mode — either
Internal or External . This function instructs the system how sources are used on
the assigned ScreenPRO-II unit(s).
At the bottom of the menu, the Status section dynamically lists the ScreenPRO-II
IDs assigned to the current destination.
{ }
Press ADD to add the selected ScreenPRO-II (on the SP to Add line) to the
current destination configuration.
{ }
Press REMOVE to remove the selected ScreenPRO-II (on the SP to Remove
line) from the current destination configuration.
{ }
Press BACK to return to the System Menu .
Important If you have configured a widescreen destination, the moment
you press
termination status of each ScreenPRO-II.
•
•
Refer to the "
section on page 119 for details.
Units are identified by their ID
Units are identified by their ID number.
{ }
BACK , the system automatically checks the
If the termination switch is properly set on each
ScreenPRO-II, no action is required.
If any termination switch is improperly set, the
ScreenPRO-II Genlock Termination Menu appears,
with instructions on how to correct the problem.
ScreenPRO-II Genlock Termination Menu
ScreenPRO-II Controller • User's Guide
"