Barco ScreenPRO-II User Manual page 60

3. Hardware Installation
Connection Charts
táÇÉëÅêÉÉå==Ô=p~ãéäÉ=asf=`çååÉÅíáçå=`Ü~êí
Each ScreenPRO-II has two DVI inputs for the Background and DSK ( BG/DSK in A and
BG/DSK in B ). Widescreen backgrounds will typically originate from a multi-head graphics
card, while single screen backgrounds are typically distributed from one computer through
a DA or signal splitter. Use the following chart to map your Background and DSK DVI
connections:
Table 3-4. Sample DVI Connection Chart
Background DVI Routing
Multi-Head
Source Graphics Card
Computer 1
Computer 2
táÇÉëÅêÉÉå=Ô=p~ãéäÉ=pí~åÇ~êÇ=aÉëíáå~íáçå=`Ü~êí
The ScreenPRO-II Controller enables you to configure up to four standard destinations.
Use the following chart to map the distribution of each destination, the usage of
BlendPRO-II if required, and the routing of your additional program and preview outputs:
Table 3-5. Sample Standard Destination Connection Chart
Standard Destinations
Output
ScreenPRO-II #1 Pgm DVI
ScreenPRO-II #1 Pgm Analog 1
ScreenPRO-II #1 Pgm Analog 2
ScreenPRO-II #1 Pvw
ScreenPRO-II #2 Pgm DVI
ScreenPRO-II #2 Pgm Analog 1
ScreenPRO-II #2 Pgm Analog 2
ScreenPRO-II #2 Pvw
60
DA
Out (or Splitter)
1 ScreenPRO-II #1, BG/DSK In A
2 ScreenPRO-II #2, BG/DSK In A
3
4
1 ScreenPRO-II #1, BG/DSK In B
2 ScreenPRO-II #2, BG/DSK In B
3
4
Dest Screen
1 Widescreen left
VGA 1
VGA 2
2 Widescreen right
VGA 3
VGA 4
Connects to:
Widescreen BG
Widescreen BG
Single screen DSK
Single screen DSK
BlendPRO-II Channel
1 R12+
2 R12+
ScreenPRO-II Controller • User's Guide
Note
Notes