Barco ScreenPRO-II User Manual page 231

6. Operations
10.
tçêâáåÖ=ïáíÜ=hÉóë=áå=péäáí=jçÇÉ
In Split Mode , the mixer's two layers operate independently .
Use the following steps to work with Keys in Split Mode .
1.
2.
3.
4.
5.
6.
7.
8.
ScreenPRO-II Controller • User's Guide
~
Press Full Screen to bring the PIP to full screen, using the source's
height as the defining factor.
~
Press Freeze to freeze the PIP (on both Program and Preview). Press
again to unfreeze.
Transition — Transition the new look to program with a CUT or AUTO TRANS .
Refer to the " Working with Transitions
Note Even though this mode allows you to display two PIPs (or
Keys) on air, it is more restrictive. Once both layers are on
Program, you must transition them off Program, make
changes — and then transition them back on.
In the Layer Control Section , ensure that the Split button is On .
Press the desired layer button ( A or B ). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the Source Selection Bus , the source assigned to the layer blinks.
~
On Preview, the raster box for the selected layer blinks (even if it is
hidden under another layer).
In the Layer Functions Section , ensure that the KEY button is lit and the Key
Menu is visible. If the menu is not visible, press KEY .
Note Even if the layer is on Program, the Key Menu appears, but
parameters can not be adjusted.
On the Source Selection Bus , select the desired (new) key source. The button
blinks to indicate that it is selected, and the source appears on Preview.
Adjust the Key's type, clip, gain, opacity, fill, size, position, source image and
cropping. Refer to the " Modifying Keys
Prior to the transition, you can set up an additional effect if desired in Split Mode :
~
To set up an additional " Split Mode " Key in Preview, repeat the
procedure from step 2.
~
To set up a PIP in Preview, refer to the "
Mode " section on page 229.
Press CUT or AUTO TRANS to transition the look to Program. Refer to the
" Working with Transitions
Repeat the procedure from step 1 for the next transition.
" section on page 241 for details.
" section on page 233 for details.
Working with PIPs in Split
" section on page 241 for details.
Working with Layers
231