Aux Destination Setup; Aux Destination Overview - Barco ScreenPRO-II User Manual

20. Repeat from step 6 for the next router that you wish to assign.
21. When you have configured all of your system's routers, on the Router
22. Press
23. Press
24. Press SAVE to save the current configuration.
^ru=aÉëíáå~íáçå=pÉíìé
ScreenPRO-II Controller system setup: Step 9
In this procedure, you will set up the system's Aux (Auxiliary) destinations.
9
The following topics are discussed:
•
•
•
^ìñ=aÉëíáå~íáçå=lîÉêîáÉï
The ScreenPRO-II Controller system provides three types of Aux destinations — Aux ,
ImagePRO Aux and PrePRO-II Aux . Each type of destination can be switched from the
ScreenPRO-II Controller by selecting it on the Destination Bus , then selecting the desired
source on the Source Selection Bus .
•
•
•
ScreenPRO-II Controller • User's Guide
Specification Menu , scroll to the Number line, and scan through the remaining
router numbers. Other than the ones which you just assigned, if there are any
router numbers that do not say <EMPTY> on the Number line, press { DELETE
ROUTER } to remove the specification from the system.
{ }
BACK to return to the System Menu .
{ }
HOME to return to the Home Menu .
Prerequisites — Ensure that you are familiar with the following menus:
~
Destination Setup Menu . In Chapter 4, refer to the "
Menu " section on page 117.
~
Aux Destination Setup Menu . In Chapter 4, refer to the "
Destination Setup
Note Up to 4 "Aux" destinations can be assigned. These are
accessible by pressing the red DEST AUX button.

Aux Destination Overview

Aux Destination Setup

ImagePRO or PrePRO-II Aux Destination Setup
An Aux destination is the output of a router, which is typically connected directly to
a monitor — rather than to the ScreenPRO-II. This type of destination is single
format (e.g., an analog monitor can only accept signals from an analog router).
An ImagePRO Aux destination is an external ImagePRO, a multi-format
processor with three inputs (one analog, one SDI and one DVI) and the ability to
scale these inputs to one common output format. Typically, the ImagePRO output
is connected to another display device such as a monitor or projector.
A PrePRO-II Aux destination is an external PresentationPRO-II, a multi-format
processor with nine inputs (eight analog and one SDI), and the ability to scale
these inputs to one common output format. Similar to ImagePRO, the PrePRO-II
output is connected to another display device such as a monitor or projector.
" section on page 120.
5. System Setup
AUX Destination Setup
Destination Setup
Aux
195