Barco ScreenPRO-II User Manual page 105

qÉëí=m~ííÉêå=jÉåì
From the Output Menu , press
B
A
C
K
Figure 4-14. Test Pattern Menu (sample)
The Test Pattern Menu enables you to display a variety of test patterns, for system and
projector alignment — for the destination selected on the Output Menu .
•
•
•
•
ScreenPRO-II Controller • User's Guide
{
TEST PATTERN
TEST PATTERN
Output Monitor
Mode
Type
Raster Box
Alignment Test Pattern
Output Monitor — selects the monitor(s) and projector(s) that are affected by the
test pattern settings. Choose between:
~
All — adjustments affect all program and preview monitors/projectors.
~
Preview — adjustments affect preview monitors only.
~
SPII Program — adjustments affect only the monitors/projectors
connected to ScreenPRO-II program outputs. With this selection, test
patterns will be data-doubled and edge-feathered.
~
BPII Program — adjustments affect only the monitors/projectors
connected to BlendPRO-II program outputs. With this selection, test
patterns will not be data-doubled and edge-feathered.
Mode — enables you to turn test patterns on or off.
Type — sets the test pattern. Choose between Off , H Ramp , V Ramp , 100%
Color Bars , 16x16 Grid , 32x32 Grid , Burst , 75% Color Bars , 50% Gray , Gray
Steps 1 , Gray Steps 2 , White , Black , Red , Green and Blue .
Raster Box — displays a raster box defined by the exact outer edges of the
selected output resolution. For example, if the output is set to 1024 x 768, the
raster box will encapsulate that exact format. Please note:
~
The Burst test pattern is the only pattern that is smaller than the selected
output resolution. When the Raster Box is enabled, the Burst pattern
will appear within its boundaries.
~
The Raster Box can be enabled when the test pattern is Off .
4. Menu Orientation
}
to display the Test Pattern Menu .
All
N
A
ON
V
Burst
On
Off
A
D
J
Output Menu
105