Barco ScreenPRO-II User Manual page 46

2. Hardware Orientation
Front Panel Sections
i~óÉê=cìåÅíáçåë=pÉÅíáçå
The figure below illustrates the Layer Functions Section .
LAYER FUNCTIONS
PIP
Figure 2-7. Layer Functions Section
The buttons in the Layer Functions Section enable you to change or modify the selected
(blinking) layer in the Layer Control Section .
PIP — press to change the selected layer (in the Layer Control Section ) and its
associated source to a PIP. The PIP Adjustment Menu appears on the Touch Screen. In
PIP Chapter 4, refer to the "
Key — press to change the selected layer (in the Layer Control Section ) and its
associated source to a Key. The Key Adjustment Menu appears. In Chapter 4, refer to
KEY
the " Key Menu
Full Screen — press to take the active PIP or Key to full screen. In each case, the
source's height is used as the parameter that defines the full screen size.
Full
Screen
In Chapter 6, refer to the "
Clone — for widescreen configurations only, press to make an exact copy of a layer onto
the opposite screen. All parameters of the PIP or Key are cloned, including the source's
Clone shadow, key effects, border and size. Once cloned, you can select between a "mirror" or
an "offset" clone.
In Chapter 6, refer to the "
Swap Z-order — press to change the visual priority (on Preview) of the two mixer layers.
The PIPs or Keys remain at their current locations — only the priority changes.
Swap
Z-order
In Chapter 6, refer to the "
46
Full
KEY Clone
Screen
PIP Adjustment Menu
" section on page 155 for details.
If a source's original dimension is 1280 x 1024, pressing Full Screen
expands (or reduces) the PIP or Key to fill the output screen vertically. If
borders are ON , they will be taken into account so that they are visible.
Using Full Screen
If Layer A is a PIP on screen 1, press Clone to make an exact copy of the
PIP on screen 2. When you adjust the PIP, both the original and the "cloned"
copy are adjusted simultaneously.
Using Clone
If the PIP on Layer B is visually on top of the PIP on Layer A , press
Swap Z-Order to place Layer A's PIP on top.
Using Swap Z-Order
Move
Swap
Move
Z-Order
Setup Source
" section on page 148 for details.
" section on page 235 for instructions.
" section on page 235 for instructions.
" section on page 236 for instructions.
ScreenPRO-II Controller • User's Guide
Mix
Swap Toggle Freeze