Barco ScreenPRO-II User Manual page 186

5. System Setup
ID Setup and Remote Enable
fa=pÉíìé=~åÇ=oÉãçíÉ=bå~ÄäÉ=
ScreenPRO-II Controller system setup: Step 1 .
In this procedure, you will set up individual ScreenPRO-II IDs and enable remote control.
1
Each ScreenPRO-II in your system must have a unique ID.
Use the following steps to set up ScreenPRO-II IDs and remote control:
1.
2.
3.
4.
186
On an individual ScreenPRO-II system, press { REMOTE CONTROL } on the
Home Menu to access the Remote Control Menu .
Scroll to the Unit ID line, and select a unique ID for the ScreenPRO-II chassis.
The ID range is 1 to 32 .
Scroll to the Remote Control/DHCP line, and enable remote control and DHCP.
Note When remote control is on, the { HOME } buttons disappears,
the ScreenPRO-II's front panel is disabled, and the unit's IP
address is dynamically assigned. All control now originates
from the ScreenPRO-II Controller's console.
Repeat steps 1 through 3 for all other ScreenPRO-II units in your system.
ScreenPRO-II Controller • User's Guide