Barco ScreenPRO-II User Manual page 187

póëíÉã=mçïÉê=ré=
ScreenPRO-II Controller system setup: Step 2 .
In this procedure, you will power up the entire system, and download code (if required).
2
Use the following steps to power up your ScreenPRO-II Controller system:
1.
2.
3.
4.
5.
6.
7.
8.
ScreenPRO-II Controller • User's Guide
Ensure that all individual ScreenPRO-II units are powered up.
Power up all routers in your system, and allows them to fully boot up. These are
your devices with static IP addresses.
Power up the ScreenPRO-II Controller, and allow it to fully boot up. This is the
system's DHCP server.
If you will be using a widescreen configuration, power up the BlendPRO-II.
Power up all PresentationPRO-II units and ImagePRO units in your system. This
sequence enables the ScreenPRO-II Controller to "serve" IP addresses to the
other peripherals.
Power up all additional peripherals, such as monitors and projectors.
Check the ScreenPRO-II Controller's Status Menu , and ensure that all devices
have been recognized. By default, this menu should appear at power up. If it is
not shown, press STATUS on the Home Menu .
Check code compatibility — when the ScreenPRO-II Controller connects to the
individual devices, it automatically checks the compatibility of the code versions.
~
If the Controller's code version matches that of the ScreenPRO-II units,
PresentationPRO-II units and BlendPRO-II, the Status Menu is shown
— and you do not need to download code.
~
If the message " Checksum Mismatch " appears on the Status Menu ,
you must download code. Please continue with the "
Code " procedure on page 188.
~
If the Controller's code version is incompatible with the code version of a
ScreenPRO-II, PresentationPRO-II or BlendPRO-II (or a combination of
units), all buttons will flash on the Controller console. The Status Menu
is shown with the message " Please Upgrade ." Please continue with the
" Downloading Code " procedure on page 188.
5. System Setup
System Power Up
Downloading
187