Barco ScreenPRO-II User Manual page 126

4. Menu Orientation
System Menu
•
•
•
•
•
In Chapter 5, refer to the "
about the system's default Input Patch Table .
126
DAs to similar ScreenPRO-II inputs, and enables all ScreenPRO-IIs to
switch simultaneously to the same input.
Note Asterisks around the ID number (e.g., *1* ) indicate that the
selected ID has not been detected by the system. However,
you can proceed with patching, and once the ID is detected,
the patch will be completed as programmed.
Router Input — Applies to Router connections
physical router input that you wish to associate with the source. The available
range depends on the number of router inputs that are defined in the Router
Specification Menu .
Note The same router input can be chosen for different source
numbers.
ScreenPRO-II Input — selects the specific input on the ScreenPRO-II.
Tally Number —
Applies to all connections
any of the eight available tallies to any input source. There are no restrictions on
tally usage. For example, inputs 1 and 8 could both map to tally 1 if desired.
Press { ADD PATCH } to confirm any change that you make on the menu. As you
dial through the choices, the " SP Input is mapped to " lines will show if the current
choice is already in use. If the patch already exists and you "add" it, you will be
asked to confirm.
{ }
Press DELETE PATCH
When pressed:
~
The Connection Type setting changes to " UNDEFINED ."
~
The Router Input line is cleared.
This procedure is an excellent starting point if you are uncertain about specific
input patch settings.
Input Patching
— this option selects the
— this option enables you to assign
to delete all input patch registers for the selected input.
" section on page 198 for important information
ScreenPRO-II Controller • User's Guide