Barco ScreenPRO-II User Manual page 99

The Color Balance Menu changes depending on the selected Input Type .
•
•
•
•
•
•
ScreenPRO-II Controller • User's Guide
ID — indicates the ID of the associated ScreenPRO-II.
Note The ID line only appears when a widescreen destination is
selected.
~
If " All " is shown in a widescreen configuration, menu values represent
those of the lowest numbered ID in the destination. When a parameter is
adjusted, all values for all ScreenPRO-II's in the destination will snap to
the new value.
~
If an individual ID is shown (e.g., 2 ), it represents that ScreenPRO-II
alone, and adjustments will only affect that unit.
Layer — for widescreen destinations, indicates the layer on which you are
adjusting the selected input.
Important In a widescreen configuration, because the electronics on
individual ScreenPRO-II scalers may not match from unit to
unit, you may be required to adjust ScreenPRO-II scalers and
layers individually — by first selecting a specific destination
ID, followed by a specific layer.
When RGB sources are selected, the Color Balance Menu provides individual
RGB contrast and brightness adjustments. Adjustment range: -25% to +25%.
~
Adjust Red Contrast and Brightness as required.
~
Adjust Green Contrast and Brightness as required.
~
Adjust Blue Contrast and Brightness as required.
When Composite , S-Video or YP
~
Adjust Saturation as required. Adjustment range: 75% to 125%.
~
Adjust Hue as required. Adjustment range (in degrees): -90.0 to 90.0.
Note When the Input Type is YP
because Hue does not apply to this type of source.
{ }
Press SAVE to save the selected input in the designated input file.
{ }
Press RESET ALL to return all parameters to 0 (zero).
4. Menu Orientation
P is selected, adjust Saturation and Hue:
b r
P , the Hue field reads N/A
b r
Input Menu
99