Barco ScreenPRO-II User Manual page 232

6. Operations
Working with Layers
tçêâáåÖ=ïáíÜ=hÉóë=áå=jáñ=jçÇÉ
In Mix Mode , the mixer's layers are ganged together. Both Keys can be perfectly co-
located on screen ( Mix Source mode), or both can operate independently ( Swap mode),
but only one Key can be on Program at a time.
Use the following steps to work with Keys in Mix Mode .
1.
2.
3.
4.
5.
6.
7.
8.
rëáåÖ=`ìí=C=cáää
A Cut + Fill key is one in which the hole-cutting information is provided by a Key on Layer
B , while the fill information is provided by an effect on Layer A (either a PIP or a Key).
Use the following steps to create a Cut & Fill Key:
1.
2.
3.
4.
5.
6.
232
In the Layer Control Section , ensure that the Split button is Off .
Press the desired layer button ( A or B ). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the Source Selection Bus , the source assigned to the layer blinks.
~
On Preview, the raster box for the selected layer blinks (even if it is
hidden under the DSK).
In the Layer Functions Section , ensure that the KEY button is lit and the Key
Menu is visible. If the menu is not visible, press KEY .
Set the desired Mix Mode :
~
To co-locate the mixer's Keys, enable the Mix Source button.
~
To locate the mixer's Keys independently, enable the SWAP button.
~
To toggle sources, enable Toggle .
On the Source Selection Bus , select the desired (new) key source. The button
blinks to indicate that it is selected, and the source appears on Preview.
Adjust the Key's mode, clip, gain, opacity, fill, size, position, source image and
cropping. Refer to the " Modifying Keys
Transition the new look to Program with a CUT or AUTO TRANS . Refer to the
" Working with Transitions
Repeat the procedure from step 1 for the next transition.
Note Cut + Fill keys can only be selected on Layer B when the
Split Mode is enabled.
In the Layer Control Section , ensure that the Split button is On .
Press the Layer A button, and configure your "fill" video as either a PIP or a Key
in the normal manner. This is the video that will appear "inside" the key.
(Typically, the fill video is a PIP.)
Press the Layer B button and select Key .
On the Key Type line, select Cut + Fill .
Use the Clip , Gain and Opacity controls to set the appearance of the fill video as
desired.
Alternate between selecting Layer A and Layer B , and use each layer's Size and
Position controls to position the fill within the key as desired.
" section on page 233 for details.
" section on page 241 for details.
ScreenPRO-II Controller • User's Guide