Barco ScreenPRO-II User Manual page 45

2. Hardware Orientation
•
•
•
•
Shift — the Shift button is a toggle: press once to light, press again to turn off. When lit,
press the desired source button to access the second row of numbered sources ( 9 - 16 ).
Shift
ScreenPRO-II Controller • User's Guide
When the Red LED above a source button is blinking :
~
The mixer is set to Mix Mode (the Split button is not lit).
~
The blinking Red LED indicates the layer that is on Program.
~
The alternate layer is enabled for modification on Preview, and its
associated raster box blinks.
The Red LED above source 1 is blinking, and the Red LED above Layer A is
blinking. This indicates that the mixer is set to Mix Mode , source 1 is on
program in Layer A , and Layer B is active for modification on Preview.
Multiple Red LEDs can be lit simultaneously, but only one Red LED can be
blinking — indicating a " Mix Mode " association between a source and a layer.
Source buttons cannot be selected if they have not been assigned during the
source setup procedure. The button will not light.
Source buttons are also used to route inputs to selected Aux destinations. In
Chapter 6, refer to the " Working with Destinations
details.
Note When the Controller is locked, source buttons are used to
enter the 4-digit password. In Chapter 6, refer to the
" Locking and Unlocking the Controller
page 252 for details.
Front Panel Sections
" section on page 222 for
" section on
45