Working With Tallies; System Backup; System Restore - Barco ScreenPRO-II User Manual

6. Operations
tçêâáåÖ=ïáíÜ=q~ääáÉë
The "Tally" function can be enabled or disabled as required.
Use the following steps to enable or disable tallies:
1.
2.
3.
Please note:
•
•
•
rëáåÖ=_~Åâìé=~åÇ=oÉëíçêÉ
The ScreenPRO-II Controller system enables you to backup and restore the complete
system setup including all Presets, using a customer supplied flash memory card. The
following topics are discussed:
•
•
póëíÉã=_~Åâìé
This procedure enables you to back up your entire system configuration. Please note the
following important points:
•
•
Use the following steps to back up your system:
1.
2.
3.
4.
5.
6.
ScreenPRO-II Controller • User's Guide
Ensure that your tallies are properly set up. In Chapter 5, refer to the "
Patching " section on page 198 for instructions.
Press { HOME } > SYSTEM to display the System Menu .
On the Tally Mode line:
~
Select On to enable all assigned tally relay closures.
~
Select Off to disable all assigned tally relay closures.
Remember that tallies are mapped to inputs. When Tally Mode is On , if a
"mapped" tally goes to Program, one of the associated eight tally circuits will be
turned on.
When the "mapped" input is removed from Program, the associated tally will turn
Off.
Tally functionality can be tested. Press { HOME } > SYSTEM > { DIAG } > { TALLY }
to initiate the test.

System Backup

System Restore

You can only store one system configuration on a Flash Memory Card.
Customer supplied Flash Memory Cards must be equal to or greater than 512MB.
Ensure that you have a (customer supplied) Flash Memory Card available.
Insert the Flash Memory Card into the Controller's rear panel Memory Card slot.
From the Home Menu , press MISC to display the Miscellaneous Menu .
Press { BACKUP RESTORE } to display the Backup/Restore Menu .
On the Device line, select Ctrlr+SP to perform a complete backup, or select a
subset as desired.
On the Controller Options line, select All , or select a subset as desired.

Working with Tallies

Input
253