Serial Upgrade Method - Barco ScreenPRO-II User Manual

`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Serial Upgrade Method

pÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ
Use the following steps to upgrade ScreenPRO-II Controller software using a serial
connection to your PC:
1.
2.
3.
4.
5.
Figure C-1. Flash Loader Utility
6.
7.
8.
272
With the download complete, navigate to the target folder and double-click the
EXE to launch the installation shield.
Follow the prompts to install the upgrade package. At the conclusion of the
procedure, a new path will be created under Start > Programs > Barco Folsom .
Connect the Console port on the back of the ScreenPRO-II Controller to the COM
1 port on your PC.
Power-up the ScreenPRO-II Controller.
On the PC, click Start > Programs > Barco Folsom > ScreenPRO-II Controller
Software #.## > Flash Loader to launch the Flash Loader utility.
Note If you have not used the COM 1 port on your PC, an error
message will be shown at the bottom of the Flash Loader.
Click Communication > RS232 Config > Baud , and select 115200.
Click Communication > RS232 Config > COM Port , and select the COM port on
your PC to which ScreenPRO-II Controller is connected. If no other programs are
using the port, the " Established communications " message appears at the
bottom of the Flash Loader.
To verify communications between the PC and ScreenPRO-II Controller:
a. In the Flash Loader, click in the black terminal window area.
b. Note the condition of the status lights:
• DCD and CTS should be red.
• TXD and RXD should be green. They will flash if Enter is
pressed.
c. Press Enter a few times to display the system prompt " # " on screen.
d. If the prompt does not appear, continue with step 9 (troubleshooting).
e. If the prompt appears, continue with step 10 (uploading files).
ScreenPRO-II Controller • User's Guide