Barco ScreenPRO-II User Manual page 104

4. Menu Orientation
Output Menu
•
•
pÉííáåÖë=jÉåì
From the Output Menu , press
B
A
C
K
Figure 4-13. Settings Menu (sample)
The Settings Menu enables you to set sync parameters for the monitors and projectors
connected to the system — for the destination selected on the Output Menu .
•
•
•
•
•
104
In widescreen configurations, BlendPRO-II is the master — whether or not you
are using an external Genlock signal.
Genlock is recommended in configurations that utilize video camera sources.
{
SETTINGS
SETTINGS
Output Monitor
Sync Out
SOG
Gamma
Raster Box Size
Output Monitor — selects the device(s) that are affected by the sync settings.
Choose between:
~
All — adjustments affect all program and preview monitors/projectors.
~
Preview — adjustments affect preview monitors only.
~
SPII Program — adjustments affect only the monitors/projectors
connected to ScreenPRO-II program outputs.
~
BPII Program — adjustments affect only the monitors/projectors
connected to BlendPRO-II program outputs.
Note Individual settings are maintained for each selection in the
Output Monitor list.
Sync Out — sets the sync value. Select +H+V , -H-V , +H-V , -H+V or CSync .
SOG — selects a specific "sync on green" signal. Choose between Off , Standard
or Tri-Level (for certain HD devices).
Gamma — sets the output gamma for the selected destination.
Raster Box Size — sets the size of the raster box that appears around PIPs and
Keys. Range (in pixels): 0 to 8 .
}
to display the Settings Menu .
All
N
A
-H-V
V
Off
1.0
1
A
D
J
ScreenPRO-II Controller • User's Guide