Restore From Flash Memory Card - Barco ScreenPRO-II User Manual

oÉëíçêÉ=Ñêçã=cä~ëÜ=jÉãçêó=`~êÇ
ScreenPRO-II Controller system setup: Step 6 (optional)
In this procedure, you will restore your system configuration from flash memory — provided
6
that you previously backed up your system to the flash memory card.
Use the following steps to restore your system from the flash memory card:
1.
2.
3.
4.
5.
6.
7.
8.
At the conclusion of this procedure, your system is completely set up — exactly the way
that you left it when you performed a complete system "backup." No further setup
operations are required. Please continue with system operations. Refer to Chapter 6,
" Operations
ScreenPRO-II Controller • User's Guide
Prerequisite — Ensure that you are familiar with the Backup/Restore
Menu . In Chapter 4, refer to the "
page 141.
Ensure that your flash memory card is properly inserted in the Controller's
MEMORY CARD slot on the rear panel.
On the Home Menu , press MISC to access the Miscellaneous Menu .
{
Press BACKUP RESTORE
Press { CHECK CARD } to ensure that the Controller recognizes the card.
On the Device line, select Ctrlr+SP to perform a complete "restore."
On the Controller Options line, select All .
On the SP to Restore line, select All .
Press { RESTORE } to restore the selected system configuration.
" on page 215 for details.

Restore from Flash Memory Card

Backup/Restore Menu
}
to display the Backup/Restore Menu .
5. System Setup
" section on
191