Barco ScreenPRO-II User Manual page 168

4. Menu Orientation
Source Adjustment Menus
As shown in the samples above, the two menus are virtually identical — and also virtually
identical to the PIP and Key Adjustment menus. The exception is that the two Source
adjustment menus pertain to the source "inside" the PIP or Key — rather than the
boundaries of the PIP or Key itself.
In this way, for example, a PIP can remain in its exact location on screen, but you can scale
or re-position the image inside the PIP.
pçìêÅÉ=^ÇàìëíãÉåí=jÉåì=cìåÅíáçåë
The following Source Adjustment Menu functions are provided:
•
•
•
•
•
•
•
For Input Source Adjustments :
•
•
168
H Size — adjusts the source's horizontal size in pixels. The " % " value indicates
the source's size as a percentage of the original PIP or Key's horizontal resolution.
The numeric value is the source's width in pixels. To adjust, use the ADJ knob or
the Joystick's Z-Axis knob.
V Size — adjusts the source's vertical size in pixels. The " % " value indicates the
size as a percentage of the original PIP or Key's vertical resolution. The numeric
value is the source's height in pixels. To adjust, use the ADJ knob or the
Joystick's Z-Axis knob.
H Position — indicates the source's horizontal position, relative to its default
horizontal position ( 00 ) with no offset. Thus, the value 50 is 50 pixels to the right
of its default position. To adjust, use the ADJ knob or move the Joystick left and
right.
V Position — indicates the source's vertical position, relative to its default vertical
position ( 00 ) with no offset. Thus, the value -10 is 10 pixels below its default
position. To adjust, use the ADJ knob or move the Joystick up and down.
Move Rate — adjusts the rate (in 0.1 second increments) for programmed Key or
PIP movement, from key frame to key frame. To adjust, use the ADJ knob or twist
the Joystick Z-Axis knob.
Key Frame Effect — indicates the "motion type" that is used to move the PIP or
Key from point to point.
Note Only the Linear motion type is supported. All other key frame
effects are ignored by ScreenPRO-II destinations.
At the bottom of each menu, the
functions:
~
{
Check the TRACK SIZE
Regardless of the PIP or Key's current aspect ratio, its size will adjust
proportionally when the Joystick's Z-Axis knob or the ADJ rotary knob is
used to change size.
~
{
Uncheck the TRACK SIZE
individually, without affecting the other parameter. In this way, you can
stretch the PIP horizontally or vertically.
{ }
Press BORDR to display the Border Menu . Refer to the "
section on page 151 for details.
{ }
Press SHDOW to display the Shadow Menu . Refer to the "
section on page 152 for details.
{ }
TRACK SIZE check box has the following
}
check box to lock H Size and V Size together.
}
check box to adjust H Size or V Size
ScreenPRO-II Controller • User's Guide
Border Menu "
Shadow Menu "