Table of Contents
Advertisement
4.1 BIOS setup
The BIOS of the single board computer (SBC) gets pre-configured at the factory. If there is anyhow the need to
access the BIOS settings some hardware configuration must be done to be able to enter the BIOS.
4.1.1 Entering the BIOS
To access the BIOS, the SBC must be connected to a monitor and a keyboard, therefore follow the steps below:
•
Halt the H
C
YDRA
OMPACT
of it, see section
3.3.3 Switching
•
Connect a monitor to the VGA connector [2] of the single board computer and a PS/2 keyboard to the PS/2
keyboard connector [6] of the single board computer, see section
•
Switch on the H
YDRA
•
Keep the DEL key of the keyboard pressed until the BIOS setup has started. If the DEL key was pressed to
late and the possibility to enter the setup has passed, restart the H
CTRL ALT DEL
RL ALT DEL.
4.1.2 BIOS settings
The table below lists the H
path
Inside Utilities -> Display Setup -> Embedded VGA/LCD/TV
Type
Inside Utilities -> Display Setup -> Set Panel Type
Take care not to use the entry »default settings« as this applies other settings than
mentioned above. Nevertheless if so, please readjust the BIOS to the above Hydra Compact
settings!
4.1.3 Finishing the BIOS changes
•
If you made necessary changes to the BIOS, safe them. Exit the BIOS.
•
Halt the H
C
YDRA
OMPACT
•
Now you can safely disconnect monitor and keyboard from the SBC.
•
The H
C
can be taken into its usual operation again.
YDRA
OMPACT
Barco – Hydra Compact – R5976568 – Revision 10 – February-2004
. When the H
C
YDRA
OMPACT
off.
C
by pressing the power switch [5] of the H
OMPACT
C
specific BIOS settings that must be selected for proper operation:
YDRA
OMPACT
Panel Type
and switch it off again, please see above.
has halted, switch it off by the power switch [5] on the front
3.2.2 Single board
YDRA
setting
CRT1 + LCD
1280x1024
TFT Color
IBM
ITSX94
fault settings« as this applies other settings than
____________________________________________________________________________________________
computer.
C
again.
YDRA
OMPACT
C
with the key combination
OMPACT
BIOS settings of H
4. Operating
] on the front
Table 4-1
C
YDRA
OMPACT
4-2
Advertisement
Table of Contents
